i usto leave my rigs fully tentioned in my garage untill one day i unriged to load in car and found that the mast was so baddly kinked at the join i coulnt pull apart .... after strapping one end to the fence so it wouldnt spin and me and dad trying to rotate the other end and pull apart ... no use .... so im looking for a 400mast18/19 stiffness 2nd hand or brandnew for cheep ......or anny other helpfull tips on how to pull it apart to straighten the conection piont up ...thanks

thiers sand /dirt stuck in the conection point ... so i cant pull it apart to fix the kink .... the small diamiter pipe that is inside the 2 other shells in kinked .... im afraid that trying to bend back will snap it off and destroy the bottom half

Nicko
Just PMed you - but if you are storing your rig under the verandah at that house, it may have been prone to UV exposure over winter. Nebbian or sausage may have some knowledge on uv exposure / mast damage. Bummer - Sunday is looking good for a NW er

Hi Nicko,
I have been in the same predicament as you have. The easiest and safest way to get your 2 piece mast apart is to remove the sail from the mast and then get hold of 2 booms and place one on the mast just above the join and the other boom just below the join. Then you have some leverage on the mast and should be able to free up the join by twisting the 2 sections.

thankyou for all your sugestions.... after clamping 2 booms on and trying to twist and rotate it deformed the carbon weave ....... so i cut the bottom part just under the conection with haxsaw and found that the last time i repaired the mast resin ran down to were the 2 parts joined ........ so basicly it was never going to come apart ...... onto a new mast ......does anny one have a 400( 18/19 stiffness) for sale cheap
thankyou

2 piece ....