thanks i will try to get the unijoint to match the chinook base.. i start seaching now for one.. great photos thanks again...don't want to change the base as its for my other board i have..

You can either replace the unijoint (the rubber bit) with a chinook uni, when the two are together they will look like this:



Of course you have to make sure that this chinook doovy will mate properly with your extension.


Or I think you might be able to replace the base with one of these:



I think I had one of these tyronsea things floating around, I'll have a look.

[edit] I just had a look, and it looks like that base was a casualty of moving house. They're pretty cheap though.

thanks maverick you have any idea in perth where i can get this chinook tendon uni.


the bit that is in your new board is a chinook two bolt base and they are very good IMO,

they are about $25 dollars last time i bought one,

Buy another one and stick it in you other board, then buy a chinook uni to fit.

IF you wanna go all out , then buy a a chinook tendon uni. i think its called a powerhaul EX or something, they are about $100 and fit into those bases , of course they are a euro pin which means u will have to buy another extension or and adaptor.

Powerhaul EX IS THE BEST euro pin uni u can get because it is made of solid stainless and is allot less likely to snap then the boge type that have a pin screwed onto a bolt hanging out of the rubber.