This is not an install question... I have reviewed a lot of those and think I am good to go. However, any tips are also welcome.

I would actually like some aesthetics advice on what you all think would be a good application of tape. I have the RSPro Tatau tape and applying it to a Pau Hana Oahu board. shown here. if I install it at the proper place on the board, I would cover some of the lettering on the side of the board. If I move it forward a few inches it would be very close but shouldn't be a big deal.

The real question is should I cover the lettering with the tape? Obviously the lettering onmy board will be distorted with the textured RSPro tape.

I was THNKING about cutting a section of the textured tape out and applying a piece of clear rail tape to maintain the look of the board. I am leaning to cutting a section out and installing a piece of clear but any opinions here are welcome.

Thanks... but I have already purchased the RSPro... I may just apply it and cut it so I can apply some clear to maintain the look of the board.

I wouldn't cut the RSPro and just cover the graphics on the board even if that means placing the rail tape a little high on the rail rather than centered.

I had to do that on my Maliko Jav like shown in this vid where I placed it right over the Naish logos.

dats why i get the clear rsp

if it's not too late, swap it

THANKS!

Appreciate all the comments.

DavidJohn, thanks for the vid and the post. I have been stalking a lot of your post... am jealous.

Nozza, perfect. That is what I was trying to envision.

I really liked the graphic on my tape and plan to move it a little forward so the graphics on the tape do not mess with the graphics on my board. I will post a pic once I am done.

I am totally over thinking this but I am a bit of an aesthetics nut... always have been. Have been driving the family nuts the last few days. hahaha.

I am new to this forum but love what I have seen so far...