well firstly paper should be on toothed side, that's what rips it cleanly

I'll go with mark, the paper should be torn across those teeth, but it's not immediately obvious how to do that. Turning that toothed section over will present the teeth to the paper. But is there anything there for the paper to run over if you do?

DARTH said..
Havnt seen one of them in ages

you get a nice warm fuzzy feeling again? you can almost smell the isocyanates again can't you

I used the paper dispenser thingo today, I just didn't use the spring that holds the paper and ripped the sheets out as needed. I centred the roll and modified the tape feeder so it didn't get out of true while I was pulling the sheets out.

It looks crap in this photo but worked well, only took about 1.5 hours to tape this trailer up.

Is there a better way or a new school approach to this type of job. As you can see I just threw old blankets and sheets Over the wheels. Rough but once again works. Sprayed the rail and rolled the deck with 2 pac valspar PU

Great job, awesome for a truck tray, if thats what it is.

Edit- cold cal. Zinc rich paint.

The valspar paint reps say..no need to cold gal, will adhere to bare steel?

That saves so much time and money.

I've sparayed / rolled/ welded the blue square tube we use to manufacturer brackets etc and The two pack rocks, even been hitting it with a hammer to test it, the two pack is really strong. I would like to hear any experiences from welders/sprayers who are in the know. Thanks again